Stream Encoder Compatibility with Spiideo Replay
This guide will help you determine whether your current streaming encoder works with Spiideo Replay, or if you need to purchase a new device. It includes:
Spiideo’s recommended hardware
A compatibility checklist for existing stream encoders
Key technical requirements for external SRT ingestion
1 encoder per external camera source delivered to Spiideo
Each encoder must comply with the Spiideo encoder requirements below
Each encoder is connected to the internet
⚠️ Important: you should use the same encoder for the same external camera for all games for that specific venue. This ensures the correct video feed is delivered to the correct 'angle' every time.
Recommended Stream Encoders for Spiideo Replay
Spiideo recommends the Videon LiveEdge Node as a reliable, hardware-based SRT stream encoder. This device has been tested in various environments and consistently meets Spiideo’s streaming requirements when configured correctly.
Videon LiveEdge Node
Product page: Videon LiveEdge Node
Support documentation: LiveEdge Node Support
SDI input specifications: SDI Specs
Purchase or sales contact: Contact Videon Sales
⚠️ Important: While Spiideo recommends this stream encoder, it’s an absolute must to verify it works with your specific setup, including compatibility with camera output signal and other equipment. See checklist below.
Already Have an Stream Encoder? Check Compatibility First
If you’re using an existing stream encoder, please review the requirements below to ensure your device is compatible.
Input Signal (Camera to Stream encoder)
Category | Item to Check | Requirement |
Connection Type | Physical input connection | SDI / HDMI / IP |
Signal Format | Stream encoder accepts signal from camera | Confirm match |
Resolution | Max supported resolution | ≤ 3840x2160 (4K) |
Aspect Ratio | Standard aspect ratio | 16:9 |
Frame Rate | Frames per second | Between 12 and 240 FPS (≤ 60 FPS recommended) |
Scan Type | Signal type | Progressive (recommended) or Interlaced (supported) |
Stream Encoder Settings: Output Video
Category | Item to Check | Requirement |
Codec | Video compression format | H.264 or H.265 |
Bitrate | Video bitrate | < 50 Mbps |
Encoding Mode | Bitrate control | Variable Bitrate (VBR) |
Keyframe Interval | GOP length | < 5s (Supports up to 11s) |
Frame Types | Types of frames used | I and P required; avoid B-frames for low latency |
Streaming Output: Stream Encoder → Spiideo Replay
Category | Item to Check | Requirement |
Protocol | Streaming method | SRT |
SRT Mode | Connection mode | Caller (Spiideo is Listener) |
SRT Settings | Address / Port / Stream ID | Set via Spiideo Replay UI |
Latency | End-to-end delay | ≤ 1 second (lens to Spiideo) |
Audio Settings (Optional)
Category | Item to Check | Requirement |
Codec | Audio compression | AAC-LC |
Sample Rate | Audio sample rate | 48 kHz |
Bitrate | Audio bitrate | ≤ 256 kbps (mono or stereo) |
Need Help?
If you’re unsure about your setup or need help verifying compatibility, reach out to support@spiideo.com.